Liquid Penetrant Inspection Accessories
Bib-style aprons protect the user from neck to knees. Material resists chemicals and mechanical wear.
Used for accurate timing of any stage of the penetrant inspection process. A two handed luminous dial permits selection of any time interval from 1 second to 60 minutes. Timers have built-in buzzers which operate when timers reach zero.
These protective PVC coated 12" gloves withstand the effects of chemicals.
PENETRANT APPLICATION HOSES
Chemical resistant hoses, 1/2" ID, 3/4" OD hoses available with 1/2" male fittings in various lengths.
A stainless steel thermometer with 6” stem and 2” diameter dial. No electrical connections. Works on the bimetal principal. Temperature range is 50 – 30° F.
An optical device for measuring the concentration of hydrophilic emulsifiers in water.
DRY POWDER DEVELOPER APPLICATORS
An air operated spray gun with aluminum quart cup for low cost small production spraying of dry powder developer. Air consumption is 3 cfm at 25 pounds. 1/4" air inlet.
|Dry Powder Developer Applicators||700610|
SHERWIN WTP-1 WASH TEST PANELS
A stainless steel panel measuring 4” x 6” and 0.090" thick with two parallel, "medium rough" strips, each 6” x 1.5” separated by a smooth 1” strip. The wash panel is used to meet monthly removability testing required by MIL-Std-6866.
|Sherwin WTP-1 Wash Test Panels||700635|
SHERWIN PSM-5 PENETRANT SYSTEM MONITOR PANELS
A stainless steel panel, 0.090" thick, and measuring 4” x 6” with a chrome-plated strip running the length of one side of the panel. Five crack centers are evenly spaced in the chrome-plating in order of magnitude; the largest is readily visible with low sensitivity penetrants, while the smallest is difficult to observe even with high sensitivity materials. Adjacent to the chrome plated section is a grit blasted area of "medium roughness" to judge penetrant wash characteristics.
The Sherwin PSM-5 Panel comes in two versions. In one version, the chrome-plated strip has been lightly grit blasted in order to dull the surface. This version complies with Pratt-Whitney P/N TAM 146040. The chrome-plated strip of the other version remains bright.
PSM-5 Panel processing meets the requirements of MIL-Std-6866 for daily system check.
A series of transparent plastic devices with high fluorescent markings which are used in the inspection booth to assess the size of defects, both linear and round; they are also used to assess the distance of a defect from a given point.
Swing Away Comparators
"Swing Away" Comparator has round and linear indications in inches ranging from .125" to .005" in acute angle "feeler gauge" style with markings on the tapered ends. Ideal for tight radius comparisons.
Round indications in inches ranging from .125" to .015". Includes five circles diameter 1/16", 3/16", 1/4", 3/8" and 1/2".
|General Electric Comparators
Round indications in inches ranging from .125" to .005". Meets GE specification.
Linear and round indications in inches with metric equivalent. Range from .180" (4.6mm) to .010" (.2mm). Meets Pratt & Whitney specification.