Magnetic Particle Inspection Accessories
Powder Bulb & Centrifuge Tubes
Increments for fluorescent magnetic particle material. Meets applicable military specifications, AMS and ASTM, etc.
CENTRIFUGE TUBE ASTM 100 ML.
Graduated 0-100 ml. in 0.10 ml. increments for non-fluorescent magnetic particle material. Meets applicable military specifications, AMS and ASTM, etc.
CENTRIFUGE TUBE STAND
|Centrifuge Tube Stand||600533|
Powder bulbs are used to apply magnetic dry powders evenly over the surface of a part that is being magnetically inspected using the dry method.
MODEL PB1 POWDER BULB
Lightweight, easy to use spray bottle. Internal magnet allows measured amount of powder to be sprayed at each puff.
|Model PB1 Power Bulb||800010|
Lightweight, easy to use spray bulb. Cap removes for easy filling.
Air puffer to blow away loose particles not being held by a flux leakage.
MAGNAFLUX MPI SPRAY SYSTEM
- 15-foot recirculation hose attached to a fan pattern spray gun.
- Fully portable unit equipped with casters for added mobility
- May be used for water or oil based solution
- Continuously agitated bath keeps the particles suspended and uniform through the tank, hose and spray gun.
- 4045 - 10%
|Magnaflux MPI Spray System||800421|
A three turn coil with a quick disconnect, made up from insulated 4/0 size flexible cable. The split coil is easily placed around or through a part and snap locked together. Other diameters can be supplied to special order. Please ask for details.
Used for testing shafts, spindles, light weight axles, and many other small parts. The Coil operates from 115-Volt AC 60 Hz and can be used to magnetize or demagnetize. Either the wet or dry method may be used. Coil is fitted with an "on-off" switch.
FLAT MAGNETIZING COIL
A new and innovative non-contact method of magnetic particle inspection, the Magnaflux Flat Magnetizing Coil allows for the quick and easy processing of several small parts at the same time. For use with any magnetic particle unit or power pack.
|Flat Magnetizing Coil||800400|